Skip to content

Bison Tix®

EAN: 8710439050560Article No.: 6305342
Super-strong, gelified, universal contact adhesive: easy to spread, does not drip and forms no strings.
  • Easy to spread
  • Does not drip
  • Forms no strings
  • Bonds immediately
  • Super-strong
  • Suitable for materials under stress
  • Universal
  • Moisture and frost resistant

Properties

  • Easy to spread
  • Does not drip
  • Forms no strings
  • Bonds immediately
  • Super-strong
  • Suitable for materials under stress
  • Universal
  • Moisture and frost resistant

Application

Suitable for:

Ideally suitable for bonding plastic panel board (such as Formica®), veneer, hardboard, synthetic edges, rubber, leather, linoleum, cork, textiles and polyether foam together and on wood, chipboard, concrete and metal. This adhesive does not drip and is therefore very suitable for vertical bonding. Excellent for bonding stair edgings, floor covering or stair carpets, furniture tips or felts, among other things. Also for repairing shoes, bags, toys and carpets, or for doing (hobby) handicraft work.

Not suitable for:

Not suitable for Polystyrene foam (Tempex®), PE, PP, PTFE and vinyl.

Handling

Before use

Working conditions

Use adhesive and parts to be bonded at room temperature only. The relative humidity must be below 65%. This is to avoid formation of bubbles in the final product. Once attached, adjustment is no longer possible. Always test on an (inconspicuous) part of the surface first.

Surface requirements

Surfaces must be dry, clean, dust- and grease-free and a good fit.

Preliminary surface treatment

Clean and degrease the surfaces to be bonded for optimal results.

Tools

Use a solid brush or fine-toothed (1 mm) glue spreader to cover large surfaces. Use a roller or rubber mallet to join the materials firmly.

Preparation of product

Stir well before use. Should preferably not be diluted

Coverage

2-2.5 m²/litre, applied on both sides, depending on the nature of the materials to be bonded.

During use

Directions For Use

Apply the adhesive thinly and evenly to both surfaces using the fine-toothed adhesive spreader (1 mm) or brush. Allow both surfaces to dry for 10 to 25 minutes. As soon as the adhesive stops stringing, join parts. Adjustment is then no longer possible. Avoid entrapping of air bubbles. Firmly tap, roll or press materials.

Points of attention

For optimum results, both the adhesive and the parts to be bonded must be at room temperature (definitely do not use below +10°C). The final bonding strength depends on the pressure applied. Therefore, press as firmly as possible across the entire surface. Should the adhesive joint between porous materials be exposed to long-lasting contact with water, the adhesive may detach from the wet surface.

After use

Stains/residue

Remove wet adhesive residue immediately. Dried excess adhesive can only be removed mechanically or with a paint stripper (pre-test).

Storage conditions

Store properly closed in a cool and frost-free place. Shelf life is a minimum 24 months.

Documents

Similar products