Epoxy Universal 2C Syringe
- Super-strong (up to 190 kg/cm²)
- Resistant to temperatures between -40 °C and +100 °C
- Filling
- Water resistant
- Chemical resistant
Properties
- Super-strong (up to 190 kg/cm²)
- Resistant to temperatures between -40 °C and +100 °C
- Filling
- Water resistant
- Chemical resistant
- Paintable
- Odourless
Application
Suitable for repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex®).
Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.
Handling
Before use
Only apply at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and the hardener.
The surface must be dry, clean and free of dust and grease.
Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper).
Mix the components by means of the supplied mixing bowl and spatula.
1:1
1 ml = approx 10 cm² at a film thickness of 1 mm
During use
Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.
Snap off the nozzle cap. Squeeze the required amount of adhesive into the mixing bowl. Mix thoroughly, then apply to one side of the area to be bonded; for rough materials, apply to both sides. Join the parts together without pressing. At room temperature, the working time is approx. 45 minutes; functional strength is achieved after approx. 6 hours and final strength after 24 hours. Heat accelerates the curing process. After use, clean the nozzle tips and seal them from the centre of the cartridge using the cap provided. Resin and hardener must not come into contact with each other unless for usage.
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.
After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Use only at temperatures between +10 °C and +35 °C
Preferably wear gloves.
After use
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.
Store in tightly closed packaging in a dry, cool and frost-free place.