Wallpaper Paste Special

Wallpaper paste on the basis of high-quality cellulose and synthetic resin.

Wallpaper Paste Special

What is it?

Back to top

What does it do?

Suitable for:

Suitable for applying all kinds of heavy, extra heavy and special wallpapers, such as woodchip, (heavy) duplex, smooth vinyl, structured vinyl, acrylic, strippable, washable, jute fabric, foamed, embossed, textile and non-woven wallpapers.

Back to top

Getting started

Before use:

Working conditions

Do not apply at temperatures below +10°C and/or relative humidity higher than 70%.

Personal safety

Physiologically safe.

Surface requirements

For an optimal result the surface must be porous, solid, clean, permanently dry, smooth, dust- and grease-free.

Preliminary surface treatment

Remove the old wallpaper using a wallpaper removal agent, then clean the surfaces in order to remove any remaining paste, grease or dust. Fill holes and cracks with wall filler to make the surface even and then coat any stains so that they do not show on the surface of the wallpaper. Prime highly absorbent surfaces first with diluted wallpapering paste (20% water). Allow this primer layer to dry for at least 2 hours. Sand non-absorbent surfaces (e.g. latex layer) by initially opening up and then making the surface dust-free.

Tools

Pasting brush, bucket, stirring stick, wallpaper table. Clean tools immediately after use with water.

Preparation of product

Add the powder in small quantities to cold water while vigorously stirring until a lump-free paste is obtained. Let the paste rest and stir up vigorously again after 10 minutes. The paste is now ready to use.

During use:

Directions for use

Coat the wallpaper strips thoroughly and evenly with a fur roller or brush, making sure the edges are properly covered. Fold the strips double and allow the paste to soak in following the instructions of the wallpaper manufacturer. Roll vinyl wallpaper after folding to prevent the edges from drying out. Apply a strip of paper to the wall and brush it smooth using a plastic spatula or brush. Always smooth the wallpaper from the centre to the edges, and from top to bottom. Make sure that the seams are properly pressed against each other.

Advice

Ready-made paste remains workable for several days when stored tightly sealed.

Points of attention

Always hang wallpaper in accordance with the manufacturer's instructions.

After use:

Stains/residue

Remove traces of paste immediately by dabbing with a clean, dry cloth. Dried paste on the surface of the wallpaper can be removed by dabbing with a clean, damp cloth.

Storage conditions

Close container properly and store in a dry, cool and frost-freeplace.

Back to top

Cookies

This site uses cookies to improve your online experience. If you want to learn more or opt out of all or some cookies, click here.