Skip to content

Silicone Neutral

EAN: 8710439144184Article No.: 6303677
Neutral, permanently elastic, water resistant silicone sealant for all construction sealings. Also suitable for sealing in acrylic baths and synthetic shower walls.
  • (Sea)water resistant
  • UV and all-weather resistant
  • Mould resistant
  • Neutral, acid-free
  • Excellent bonding without primer
  • Permanently elastic
  • Chemical resistant
  • Colourfast
  • Resistant to temperatures between -40 °C and +100 °C
  • Easy to apply

Properties

  • (Sea)water resistant
  • UV and all-weather resistant
  • Mould resistant
  • Neutral, acid-free
  • Excellent bonding without primer
  • Permanently elastic
  • Chemical resistant
  • Colourfast
  • Resistant to temperatures between -40 °C and +100 °C
  • Easy to apply

Application

Suitable for:

Suitable for sealing moving joints, dilatation and connection joints, seams and cracks in construction, houses, cars, boats and caravans. Ideal for synthetics (PVC door and window frames, polycarbonate and plexiglas domes), stone and masonry and (sensitive) metal (copper, zinc, iron, aluminium, brass, stainless steel). Universal adhesion without primer on all common building materials, such as concrete, stone, (natural) stone, ceramics, enamel, glass, metal, rubber, wood and synthetics (acrylic, PVC, ABS, polystyrene, polyester). Does not bond to bitumen, polyethylene, polypropylene and PTFE.

Handling

Before use

Working conditions

Only apply at temperatures between +5 °C and +40 °C.

Surface requirements

The surface must be dry, clean and free of dust, rust, paint and grease.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.

Tools

Apply cartridge with a Power Pistol. Multi Tool to open the cartridge and tooling the sealant.

Coverage

Content suitable for approx. 8 to 15 m (depending on the diameter of the joint).

During use

Handling Of Packaging

Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.

Directions For Use

Ensure a minimum joint width of 6 mm and a maximum of 20 mm. The joint depth depends on the joint width. Keep a joint depth of 6 mm up to a joint width of 12 mm. Beyond that, the joint depth should be half the joint width. Apply the sealant evenly into the joint, then within 10 minutes tool with a sealant smoother or BISON Multi Tool moistened with a non-aggressive or mild soap solution. Remove the applied masking tape immediately after tooling. After approx. 15 minutes, a surface skin will form. Cured silicone sealant can only be removed mechanically. For aquariums use only BISON Silicone Sealant Glass.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Alijd consider a joint of at least 6 mm wide.

After use

Stains/residue

Immediately remove stains with white spirit. The cured sealant can only be removed mechanically or with BISON silicone sealant residue remover.

Storage conditions

Store in properly sealed packaging in a dry place at between +5 °C and +25 °C.

Documents

Similar products