Flooring Adhesive

Suitable for:

Suitable for bonding floor coverings and carpet tiles with jute, felt or textile backing, linoleum and wall cork on porous surfaces such as cement, concrete and wood.

• Technical documentation

Working conditions

Do not apply at temperatures below +15 °C and/or relative humidity higher than 65 %.

Surface requirements

The surface must be clean, dry, free of dust and grease.

Preliminary surface treatment

First level damaged or uneven floors.

Tools

Glue spreader No. 2.

Coverage

2-3 m²/kg

Directions for use

Spread the glue (clean, dry and grease-free surface) evenly with a glue spreader. Place floor covering, linoleum or wall cork in the still wet adhesive within about 15 minutes and press or roll firmly. During these 15 minutes, adjustments can still be made. The adhesive joint can be loaded after 24-48 hours.

Points of attention

When bonding to wooden surfaces endorsement of the seams can occur. The adhesive bond can only be loaded after curing. The smell of the glue disappears after curing. We recommend to always observe the instructions of the manufacturer.

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store in tightly closed container in a dry, cool and frost-free place.