Skip to content

PVAC Wood Adhesive D2

EAN: 8710439042435Article No.: 6305293
High quality, moisture resistant (EN 204 D2) white wood glue for indoor use. Dries transparent. Stronger than wood. For bonding and laminating of practically all hard, soft and exotic types of wood.
  • Stronger than wood
  • Transparent when dry
  • Ideal for interior applications (EN 204 D2)
  • Paintable
  • Solvent-free

Properties

  • Stronger than wood
  • Transparent when dry
  • Ideal for interior applications (EN 204 D2)
  • Paintable
  • Solvent-free

Application

Suitable for:

For moisture resistant bonding and laminating of practically all hard, soft and exotic types of wood. Suitable for well-fitting, non-load bearing wooden structures using, for example, finger joints, dovetail joints, mortise and tenon joints, dowels and springs. Suitable for indoor applications such as doors and furniture in, for example, living rooms and offices. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. EN 204 D2: Interior spaces in which increased relative humidity occurs occasionally and for a short time, whereby the level of wood humidity remains below 18 %.

Handling

Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5 °C. Relative humidity of up to 65 %. Level of wood humidity between 8 % and 12 %.

Surface requirements

The surfaces to be bonded need to be clean, dry and free of dust. Ensure a well-fitting joint.

Preliminary surface treatment

Greasy wood types should be degreased.

Tools

Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.

Dilute

Dilute only with water.

Coverage

2-4 m²/kg, applied on both sides, depending on the nature of the materials.

During use

Directions For Use

Apply the adhesive with a brush or some other tool in an even and thin layer on one or both parts. Let penetrate for a few minutes, the assemble the parts and clamp or press for 1-2 hours. The desired pressure is 2-5 kg/cm².

After use

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Close container properly and store in a dry, cool and frost-free place.

Documents

Similar products