Skip to content

Bison Kit® Shoe Glue

EAN: 8710439283456Article No.: 6314465
Super-strong, crystal clear, universal contact adhesive based on polyurethane rubber, resins and solvents.
  • Crystal clear
  • Bonds immediately
  • Super-strong
  • Does not discolour
  • Suitable for materials under stress
  • Universal
  • Moisture and frost resistant
  • Simple to use

Properties

  • Crystal clear
  • Bonds immediately
  • Super-strong
  • Does not discolour
  • Suitable for materials under stress
  • Universal
  • Moisture and frost resistant
  • Simple to use

Application

Suitable for:

Ideally suitable for bonding many transparent materials, such as plexiglas, perspex, polycarbonate. Also bonds (synthetic) leather, vinyl, soft PVC, cork, canvas, textiles and many rigid and soft synthetics including PVC, ABS and polystyrene. Very suitable for repairing items such as shoes, bags, toys, book covers, name plates and creating (hobby) handicraft work. Ideally suitable for bonding PVC pond liner.

Not suitable for:

Not suitable for Polystyrene foam (Tempex®), PE, PP, PTFE and vinyl.

Handling

Before use

Working conditions

Use adhesive and parts to be bonded at room temperature only. The relative humidity must be below 65%. This is to avoid formation of bubbles in the final product. Once attached, adjustment is no longer possible. Always test on an (inconspicuous) part of the surface first.

Surface requirements

Surfaces must be dry, clean, dust- and grease-free and a good fit.

Preliminary surface treatment

Clean and degrease the surfaces to be bonded for optimal results.

Tools

Use a solid brush or fine-toothed (1 mm) glue spreader to cover large surfaces. Use a roller or rubber mallet to join the materials firmly.

Preparation of product

Should preferably not be diluted

Coverage

2-2.5 m²/litre, applied to both sides, depending on the nature of the materials to be bonded.

During use

Directions For Use

Apply the adhesive thinly and evenly to both surfaces using the fine-toothed adhesive spreader (1 mm) or brush. Allow both surfaces to dry for 10 to 25 minutes. As soon as the adhesive stops stringing, join parts. Adjustment is then no longer possible. Avoid entrapping of air bubbles. Firmly tap, roll or press materials.

Points of attention

For optimum results, both the adhesive and the parts to be bonded must be at room temperature (definitely do not use below +10°C). The final bonding strength depends on the pressure applied. Therefore, press as firmly as possible across the entire surface. Should the adhesive joint between porous materials be exposed to long-lasting contact with water, the adhesive may detach from the wet surface.

After use

Stains/residue

Remove wet adhesive residue immediately. Dried excess adhesive can only be removed mechanically or with a paint stripper (pre-test).

Storage conditions

Store properly closed in a cool and frost-free place. Shelf life is a minimum 24 months.

Documents

Similar products