Bison Kit®

Bottle with brush 400 ml

Super-strong, liquid, universal contact adhesive with integrated brush

Bison Kit®

What is it?

Back to top

What does it do?

Suitable for:

Ideally suited for surface bonding or laminating of many materials that require immediate bonding, loading or processing. Bonds wood, board, veneer, plastic and metal panel boards (HPL, Formica®, for example), (foam) rubber, leather, cork, canvas, linoleum and polyether foam (sound insulation), among other things, to itself as well as to many other surfaces. Also for repairing shoes, bags, toys and carpets, or for doing (hobby) handicraft work.

Not suitable for:

Not suitable for Polystyrene foam (Tempex®), PE, PP, PTFE and vinyl.

Back to top

Getting started

Before use:

Working conditions

Use adhesive and parts to be bonded at room temperature only. The relative humidity must be below 65 %. This is to avoid formation of bubbles in the final product. Once attached, adjustment is no longer possible. Always test on an (inconspicuous) part of the surface first.

Surface requirements

Surfaces must be dry, clean, dust- and grease-free and a good fit.

Preliminary surface treatment

Clean and degrease the surfaces to be bonded for optimal results.

Preparation of product

Stir well before use. Should preferably not be diluted

Coverage

2-2.5 m²/litre, applied on both sides, depending on the nature of the materials to be bonded.

During use:

Directions for use

Parts must be clean, dry and free of grease. Coat both substrates completely. Allow to dry for a minimum of 10-40 minutes. In case of porous materials, apply a second coat and let dry. Then join parts and roll or tap firmly (with a rubber mallet).

Points of attention

For optimum results, both the adhesive and the parts to be bonded must be at room temperature (definitely do not use below +10 °C). The final bonding strength depends on the pressure applied. Therefore, press as firmly as possible across the entire surface. Should the adhesive joint between porous materials be exposed to long-lasting contact with water, the adhesive may detach from the wet surface.

After use:

Stains/residue

Remove wet adhesive residue immediately. Dried excess adhesive can only be removed mechanically or with a paint stripper (pre-test).

Storage conditions

Store properly closed in a cool and frost-free place. Shelf life is a minimum 24 months.

Back to top

Similar products

Back to top