Preparation: Lay out all the materials you need for this job.
Cleaning: Thoroughly clean the back of the glass plate with a lint-free cloth and household ammonia.
Now clean the wall removing dust and grease.
Fitting the splash-back plate: Apply Poly Max® in vertical lines every 20 cm.
Only make vertical lines to prevent trapping moisture and therefore penetrating damp spots. Start and end the adhesive lines approximately 5 cm from the edges to prevent the Poly Max® oozing out from behind the glass plate.
Place the glass plate against the wall within 10 minutes.
Position the glass plate then press firmly. Use distance pieces to get the glass plate into the right position.
The glass plate is ready to seal after 2 hours.
Sealing the splash-back plate: Work from a corner, with the oblique side of the nozzle pointing downwards.
If necessary, use a new nozzle for the correct diameter.
Admire the result!