Ideal for small-area bonds. Glues all common types of plastics, like PE, PP, PVC, PS, ABS, rubber, and much more.

Not suitable for PTFE, Styrofoam®, leatherwear, and clothing textiles.

Do not use at temperatures below +10 °C. The glue responds best to an air humidity level of 50-70 %.

Surfaces to be glued must be clean, dry, free of dust and grease, and must fit exactly.

Any dust, oil, grease, wax or separating agent should be thoroughly removed from the surfaces to be stuck together. The best way to achieve this is to rub the parts a number of times with appropriate solvents, such as acetone (if suitable for the material – check first!). For metals and metal alloys it is usually sufficient to roughen the surface using emery paper or by grinding or brushing.

1. Apply activator (No. 1) on both sides of the surfaces to be glued. Allow to dry for 60 sec. Close activator pen immediately after use. 2. To open the glue (No. 2), turn the whole cap clockwise firmly onto the tube. Unscrew the top cap to reveal applicator. Apply a thin layer of adhesive to one side. Press parts together immediately. After use: Clean nozzle with a dry tissue and replace cap.

When glueing at low humidity, curing time can be shortened by briefly breathing onto one of the parts to be assembled. The best glueing results are reached at room temperature.

Contains cyanoacrylate. Bonds skin and eyelids together in seconds. If product comes into contact with the eyes, rinse immediately with plenty of water and seek medical advice. In case of contact with skin, glue can be dissolved by soaking in warm soapy water. Then apply a skin cream. May cause respiratory irritation. Avoid breathing vapours. Keep out of the reach of children.

Wipe off excess glue immediately with a dry cloth. After curing, glue residue is very difficult to remove. Acetone will dissolve glue but very slowly (check suitability first).

Store in a dry, cool, frost-free place. Storage below +5 °C (in refrigerator) ensures maximum shelf life.