Skip to content

PVAC Wood Adhesive D3

EAN: 8710439041650Article No.: 1539023
High quality, water resistant (EN 204 D3) white wood glue for indoor and outdoor use. Dries transparent. Stronger than wood. For bonding and laminating of practically all hard, soft and exotic types of wood.
  • Water resistant (EN 204 D3)
  • Stronger than wood
  • Ideal for internal and external applications
  • Transparent when dry
  • Paintable
  • Solvent-free

Properties

  • Water resistant (EN 204 D3)
  • Stronger than wood
  • Ideal for internal and external applications
  • Transparent when dry
  • Paintable
  • Solvent-free

Application

Suitable for:

For the water resistant joining and laminating of practically all hard, soft and exotic woods. Suitable for well-fitting, non-load bearing wooden structures using, for example, finger joints, dovetail joints, mortise and tenon joints, dowels and springs. Suitable for indoor and outdoor applications, especially for glue joints that demand water resistance. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface. D3: Interior spaces in which passing water, condensation and / or heavy stress due to increased relative humidity occurs frequently for a short time. Exteriors not exposed to weather influences.

Handling

Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5 °C. Relative humidity of up to 65 %. Level of wood humidity between 8 % and 12 %.

Surface requirements

The surfaces to be bonded need to be clean, dry and free of dust. Ensure a well-fitting joint.

Preliminary surface treatment

Greasy wood types should be degreased.

Tools

Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.

Dilute

Dilute only with water.

Coverage

2-4 m²/kg, applied on both sides, depending on the nature of the materials.

During use

Directions For Use

Apply the adhesive with a brush or some other tool in an even and thin layer on one or both parts. Let penetrate for a few minutes, the assemble the parts and clamp or press for 30-60 minutes. The desired pressure is 2-5 kg/cm².

After use

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Close container properly and store in a dry, cool and frost-free place.

Documents

Similar products