Car Mirror Adhesive

Rearview mirror adhesive

Car Mirror Adhesive

What is it?

Back to top

What does it do?

Back to top

Getting started

Before use:

Working conditions

Do not use at temperatures below +15ºC. At lower temperatures, heat inside of car (windscreen).

Preliminary surface treatment

Make sure parts (windscreen and metal mirror base) are clean, dry and free of grease. Remove all old adhesive- and tape residue. There should be no condensation on windscreen.

During use:

Directions for use

Mark intended position of mirror on outside of windscreen. Attention: due to tension on windscreen, this should be the exact same position as before. Cut the enclosed mesh in form and size of mirror base. Apply adhesive from syringe evenly and generously on mirror base. Press mesh cut to size into wet adhesive and press mirror base to marked area. Hold firmly for at least 5 minutes. Any movement of mirror base during this period will result in a bad adherence. Let cure for at least 15 minutes before adjusting mirror position.

Points of attention

  • Bison Car Mirror is an anaerobic adhesive, meaning that it is designed to cure in absence of oxygen, in combination with the impregnated mesh. Adhesive outside bonded areas will not cure due to presence of oxygen.

After use:

Stains/residue

Remove stains immediately with acetone.

Storage conditions

Store in a dry, cool and frost free place.

Back to top

Cookies

This site uses cookies to improve your online experience. If you want to learn more or opt out of all or some cookies, click here.