Skip to content

Silicone Universal

EAN: 8710439101088Article No.: 6305451
High quality, universal, permanently elastic, water resistant sealant on an acetic acid base. Can be used indoors and outdoors. UV and all-weather resistant.
  • (Sea)water resistant
  • Permanently elastic
  • UV and all-weather resistant
  • Mould resistant
  • Excellent bonding on all surfaces
  • Chemical resistant
  • Colourfast
  • Easy to apply
  • Resistant to temperatures between -50°C and +120°C

Properties

  • (Sea)water resistant
  • Permanently elastic
  • UV and all-weather resistant
  • Mould resistant
  • Excellent bonding on all surfaces
  • Chemical resistant
  • Colourfast
  • Easy to apply
  • Resistant to temperatures between -50°C and +120°C

Application

Suitable for:

Suitable for sealing joints, seams and cracks in all kinds of applications. Suitable for sealings in sanitary and construction applications, for example in the house, glass construction, display case construction, car, boat and caravan. Also suitable for bonding and sealing clear glass, display cases and display windows. Adheres to almost all materials. Not suitable for bitumen, polyethylene, polypropylene, PTFE and aquariums.

Not suitable for:

Not suitable for polyethylene (PE), polypropylene (PP), PTFE and bitumen.

Handling

Before use

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

The surface should be dry, clean and free of dust and grease. Synthetics should first be roughened and/or pre-treated with BISON Silicone Primer.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.

Coverage

1 tube for approx. 1.5 m (depending on the diameter of the joint).

During use

Handling Of Packaging

Screw the cap from the tube and pierce the tube membrane with the point at the top of the cap in a twisting movement. Screw synthetic nozzle onto the tube and then cut diagonally.

Directions For Use

Inject the sealant evenly into the joint and tool within 10 minutes with a putty knife, moistened with a soap solution. Remove the applied masking tape immediately after tooling. After approx. 15 minutes, a surface skin will form.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Always consider a joint of at least 6 mm wide. By applying masking tape along the joints completely smooth seams are achieved, remove the tape immediately after smoothing.

After use

Stains/residue

Immediately remove stains with white spirit. Cured sealant can only be removed mechanically.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Documents

Similar products