What is it?
- Easy to apply
- Not moisture resistant
What does it do?
Suitable for bonding floor coverings and carpet tiles with jute, felt or textile backing, linoleum and wall cork on porous surfaces such as cement, concrete and wood.
Do not apply at temperatures below +15°C and/or relative humidity higher than 65%.
The surface must be clean, dry, free of dust and grease.
Preliminary surface treatment
First level damaged or uneven floors.
Bison Glue spreader No. 2.
Directions for use
Smear the substrate (clean, dry and free of grease) evenly using a Bison glue spreader No.2. Place floor covering, linoleum or wall cork within about 15 minutes into the still wet adhesive and firmly press or roll. During these 15 minutes adjustments can still be made. After 24-48 hours the adhesive bond can be loaded.
Points of attention
When bonding to wooden surfaces endorsement of the seams can occur. The adhesive bond can only be loaded after curing. The smell of the glue disappears after curing. We recommend to always observe the instructions of the manufacturer.
Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.
Store in tightly closed container in a dry, cool and frost-free place.