What is it?
Properties
- Immediate bonding
- Easy to apply
- Permanently neat result
- Water resistant
- Decorative
What does it do?
Suitable for:
Suitable for: precise, decorative waterproof sealing of joints along the bath, shower basin, countertop, sink and floor.
Getting started
Before use:
Working conditions
Only apply at temperatures above +10°C.
Preliminary surface treatment
Thoroughly clean the surface using an abrasive and carefully remove old sealant residue. Treat irregularities in the surface, such as deep tile joints, with a fine filler. Degrease the surface thoroughly with methylated spirits, acetone or ammonia (not white spirit!) and allow to dry properly
Tools
Scissors, cutter.
During use:
Directions for use
Cut the sealant strip to size, observing 10-15 mm clearance. Start with the longest joint. Fold double the strip along its entire length and pull back a part of the backing tape. Place the beginning of the strip on the joint and apply the strip while firmly pressing downward. Please note: do not stretch the strip as you press! Cut off the excess strip at the end of the joint. Make sure the strip adheres well everywhere (especially in the tile joints), then apply the other strip(s) in the same way. In corners, overlap strips. Cut the overlapping pieces from the corner at an angle (45°) and remove the pieces. Press the corner again firmly.
After use:
Stains/residue
Remove tape residue with white spirit
