Skip to content

SILICONE SEALANT SANITARY

EAN: 8710439144023Article No.: 6306989
High-quality, permanently elastic and water resistant silicone sealant on an acetic acid base for sanitary seals. Resistant to mould. Loadable with water after 2 hours.
  • Mould resistant
  • 2 hr Topspeed quality
  • (Sea)water resistant
  • Chemical resistant
  • Colourfast
  • Permanently elastic
  • UV and all-weather resistant
  • Resistant to temperatures between -50°C and +150°C
  • Easy to apply

Properties

  • Mould resistant
  • 2 hr Topspeed quality
  • (Sea)water resistant
  • Chemical resistant
  • Colourfast
  • Permanently elastic
  • UV and all-weather resistant
  • Resistant to temperatures between -50°C and +150°C
  • Easy to apply

Application

Suitable for:

Suitable for sealing joints, seams and cracks in bathrooms, kitchens, toilets and showers. Specifically for sealings in sanitary and ceramic applications, such as joints between wall tiles and bath tubs, shower cubicles, bathroom sinks, kitchen counters, sinks and between tiled walls. Adheres to clear glass, ceramics, glazed tiles, enamel, metal, wood and various synthetics. Does not bond to bitumen, polyethylene, polypropylene and PTFE. For acrylic baths, shower basins and synthetic shower walls use BISON Silicone Sealant for Acrylic Baths.

Not suitable for:

Not suitable for aquariums, acrylic, bitumen, polyethylene (PE), polypropylene (PP) and PTFE

Handling

Before use

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

The surface must be dry, clean and free of dust, rust, paint and grease. Synthetics must first be roughened.

Preliminary surface treatment

For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.

Tools

Apply cartridge with a Power Pistol. Multi Tool to open the cartridge and tooling the sealant.

Coverage

Content suitable for approx. 8 to 15 m (depending on the diameter of the joint).

During use

Handling Of Packaging

Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.

Directions For Use

Ensure a minimum joint width of 6 mm and a maximum of 20 mm. The joint depth depends on the joint width. Keep a joint depth of 6 mm up to a joint width of 12 mm. Beyond that, the joint depth should be half the joint width. Apply the sealant evenly and smooth it within 10 minutes with a mild soap solution (use BISON Multi Tool). Remove the applied masking tape immediately after tooling. After approx. 15 minutes, a surface skin will form. Cured silicone sealant can only be removed mechanically.

Points of attention

Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing. Alijd consider a joint of at least 6 mm wide. By applying masking tape along the joints completely smooth seams are achieved, remove the tape immediately after smoothing. The sealant is loadable with water after 2 hours, however, do not touch or load mechanically.

After use

Stains/residue

Immediately remove stains with white spirit. Cured sealant can be removed mechanically or with BISON silicone sealant residue remover.

Storage conditions

Store in properly sealed packaging in a dry place at between +5°C and +25°C.

Documents

Similar products