Montagekit Polystyrene

Cartridge 470 g

Strong, solvent-free assembly adhesive based on acrylic dispersion

Montagekit Polystyrene

What is it?

Back to top

What does it do?

Suitable for:

Ideal for assembling all kinds of polystyrene foam objects and (heavy) decorative elements on porous (absoring) surfaces such as concrete, stone, plasterwork, wood and chipboard. Very suitable for attaching, e.g., insulation boards, decoration plates, ceiling tiles, decorative materials in polystyrene foam such as ornaments and decorative edgings. Also extremely suitable for surface bonding.

Not suitable for:

Not suitable for PE, PP, PTFE, bitumen, mirrors, natural stone, permanently moist places and for attaching a non-porous material on a non-porous substrate. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic.

Back to top

Getting started

Before use:

Working conditions

Only apply at temperatures between +5 °C and +40 °C.

Surface requirements

Both parts must be dry, clean and free of dust and grease. One of the two parts must be porous (absorbent).

Tools

Use putty knife or spatula to apply. If necessary, use a rubber mallet to tap lightly. For surface bonding use a glue spreader (2 mm).

Preparation of product

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm).

Coverage

Wall covering sheets and panels: about 5-8 m²/kg depending on the weight of the material. Lathing, skirting boards and timber framework: about 4-6 m²/kg glued surface.

During use:

Handling of packaging

Cut off screw thread, assemble nozzle and cut to a diameter of at least 0.5 cm.

Directions for use

Depending on the weight of the material, apply the adhesive evenly in strips or dots at intervals of between 20 and 30 cm. Always apply adhesive to the corners and along the edges. For surface bonding apply adhesive thinly and evenly on one side using a glue spreader. Assemble materials with a sliding movement and press or hammer firmly together. Correction is still possible. For heavy materials, fastenings or supports may be required.

After use:

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Close container properly and store in a dry, cool and frost-free place.

Back to top