Suitable for fast, strong and invisible repair of many materials, such as pottery, porcelain, glass, leather, wood, stone, metal, ceramics. Both with themselves and in combination.

Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

Recommended application at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and hardener.

The surface must be dry, clean and free of dust and grease.

Degrease parts to be bonded with denatured alcohol. Roughen smooth surfaces (sandpaper).

Clean tools immediately after use with warm water and soap.

1:1

1 ml = approx 10 cm² at a film thickness of 1 mm

Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.

Inject both components in equal volume quantities in the mixing bowl. Next, mix the adhesive thoroughly with the supplied spatula until a homogenous mass is obtained. The mixture can, at room temperature (20 °C), be processed for about 5 minutes. Apply adhesive immediately after mixing on both parts. Join parts immediately and press firmly. The functional strength is reached after 20 min, final bonding strength after 12 h (both at room temperature).

Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.

Preferably wear gloves.

Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Store in tightly closed packaging in a dry, cool and frost-free place.