Skip to content

Epoxy Metal

EAN: 8710439153100Article No.: 6305443
Strong, metal coloured two-component epoxy adhesive
  • Extreme strength: up to 220 kg/cm²
  • Metal coloured
  • Resistant to harsh conditions
  • Resistant to temperatures between -40 °C and +120 °C
  • Filling
  • (Sea)water resistant
  • Very good chemical resistance
  • Can be sanded, filed, drilled and painted after curing

Properties

  • Extreme strength: up to 220 kg/cm²
  • Metal coloured
  • Resistant to harsh conditions
  • Resistant to temperatures between -40 °C and +120 °C
  • Filling
  • (Sea)water resistant
  • Very good chemical resistance
  • Can be sanded, filed, drilled and painted after curing

Application

Suitable for:

Ideal for strong repairs of metal objects which must withstand extreme conditions (forces, vibrations, (sea)water, heavy load), such as tools, car parts, engines, (motor)bikes, metal (garden) fencing and cutlery. Also suitable for sealing a small hole in a radiator. Suitable for bonding of metal (steel, aluminium, iron) together and in combination with stone, wood, concrete, and various synthetics (such as formica, polyester and bakelite).

Not suitable for:

Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

Handling

Before use

Working conditions

Recommended application at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and hardener.

Surface requirements

The materials to be bonded must be dry, clean, free of dust and grease.

Preliminary surface treatment

Degrease parts to be bonded with acetone. Roughen smooth surfaces (sandpaper).

Tools

Mix the components in the double-syringe by means of the supplied mixing bowl and spatula.

Mixture ratio

1:1

Coverage

1 ml = approx 10 cm² at a film thickness of 1 mm

During use

Handling Of Packaging

Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.

Directions For Use

Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a synthetic spatula until a mixture is obtained with a homogeneous colour. Apply the mixture, which at room temperature (+20 °C) remains toolable for about 45 minutes, as a thin layer on one of the two materials. Join the materials and keep them in place for 10 hours. Be careful not to move the parts before the adhesive has cured. After use, clean the nozzle with a cloth and place the special cap in the handle on the double syringe. Resin and hardener must not come into contact with each other unless for usage.

Points of attention

After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.

Personal Safety

Preferably wear gloves.

After use

Stains/residue

Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions

Store cool, dry, frost-free, upright (nozzle upwards) and tightly closed.

Documents

Similar products