Skip to content

Montagekit Interior Finish

EAN: 8710439048604Article No.: 6303959
Solvent-free assembly adhesive based on acrylate.
  • High final bonding strength
  • Solvent-free
  • Permanently elastic
  • Filling capacity
  • Paintable


  • High final bonding strength
  • Solvent-free
  • Permanently elastic
  • Filling capacity
  • Paintable


Suitable for:

For bonding and assembling many building materials on virtually all substrates, such as polystyrene foam, wood, metal, synthetics, ceramic, stone, plasterwork and (cellular) concrete. Suitable for internal applications, such as timber framework, skirting boards, paneling, laths, doorsteps, window sills, drywalls, sheet and insulation material, decorative edging and decorative materials. Only applicable if at least one of the two surfaces is porous.

Not suitable for:

Not suitable for gluing materials under tension, PE, PP and bitumen.


Before use

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5°C.

Surface requirements

Both parts must be dry, clean and free of dust and grease. One of the two parts must be porous (absorbent).


Sealant gun and rubber hammer.

Preparation of product

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm).


With spot bonding: 5-8 m²/kg. Stripes: one cartridge issues approx. 8-15 metres of adhesive (depending on the diameter of the cut nozzle).

During use

Handling Of Packaging

Cut off screw thread, assemble nozzle and cut to a diameter of at least 0.5 cm.

Directions For Use

Depending on the weight of the material, apply the adhesive evenly in vertical strips or dots at intervals of between 10 and 30 cm. Always apply adhesive to the corners and along the edges. Assemble materials with a pushing movement and press or knock firmly together. Correction is still possible. For heavy materials fasten or support where necessary. Close the cartridge properly immediately after use.

Points of attention

This mounting adhesive is white when it comes out of the cartridge. This mounting adhesive dries transparent. Depending on the materials and ambient circumstances (e.g. temperature), this may take some time. When bonding pure gypsum materials first do a test bonding. If the surface is very loose, first treat with a penetrating primer or fixation agent.

After use


Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Store dry in sealed packaging between +5°C and +25°C.


Similar products