What is it?
Properties
- Fast
- Crystal clear
- Super-strong
- Universal, suitable for many materials
- Resistant to temperatures between -40 °C and +100 °C
- Filling
- Water resistant
- Chemical resistant
- Paintable
What does it do?
Suitable for:
Suitable for fast, strong and invisible repair of many materials, such as pottery, porcelain, glass, leather, wood, stone, metal, ceramics. Both with themselves and in combination.
Not suitable for:
Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.
Getting started
Before use:
Working conditions
Recommended application at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and hardener.
Personal safety
Preferably wear gloves.
Surface requirements
The surface must be dry, clean and free of dust and grease.
Preliminary surface treatment
Degrease parts to be bonded with denatured alcohol. Roughen smooth surfaces (sandpaper).
Tools
Clean tools immediately after use with warm water and soap.
Mixture ratio
1:1
Coverage
1 ml = approx 10 cm² at a film thickness of 1 mm
During use:
Handling of packaging
Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.
Directions for use
Inject both components in equal volume quantities in the mixing bowl. Next, mix the adhesive thoroughly with the supplied spatula until a homogenous mass is obtained. The mixture can, at room temperature (20 °C), be processed for about 5 minutes. Apply adhesive immediately after mixing on both parts. Join parts immediately and press firmly. The functional strength is reached after 20 min, final bonding strength after 12 h (both at room temperature).
Advice
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.
Points of attention
After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.
After use:
Stains/residue
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.
Storage conditions
Store in tightly closed packaging in a dry, cool and frost-free place.
