What is it?
- Fast curing: 5-10 minutes
- Easy to apply
- Can be used internally and externally
- Water resistant: suitable for continuous water exposure
- Even cures under water!
- Does not distort
- No shrinkage: remains in original form
- Chemical resistant
- Grinding, drilling, sawing and painting possible after curing
What does it do?
Rock solid dual-component epoxy putty.
Not suitable for:
Not suitable for Polyethylene (PE), polypropylene (PP), PTFE.
Only apply at temperatures between +15 °C and +25 °C.
Preferably, process with gloves. After use, wash hands immediately and thoroughly with soap and water.
The materials to be bonded must be dry, clean, free of dust and grease.
Preliminary surface treatment
Degrease parts to be bonded with acetone. Roughen smooth surfaces (sandpaper).
A moist knife to cut off the required amount from the stick.
Directions for use
Cut the required quantity from the rod with a damp knife (reinsert foil). Knead with your fingers until a homogeneous colour (dark gray) is obtained. If kneading is difficult, bring the rod at room temperature. Apply within 2 minutes after mixing and put into shape. Cut off excess mass with a knife. Remove fingerprints by rubbing with water or a damp cloth before curing starts.
Remove fingerprints by rubbing with water or a damp cloth before curing starts.
Store cool, dry, frost-free and tightly closed.